Longyu-Xiangmin Peninsula water heater project in Qingxiu District of Nanning

Space energy water heater is an energy-saving household water heater, which has the advantages of convenient and fast use and high safety factor. Of course, there are certain requirements and precautions for the installation of space energy water heater. Next, we will follow the Guangxi hot water project editor to learn about it. 

Installation position: for the space energy water heater at a higher position, lightning rod should be installed at the top to prevent lightning strike and cause accidents. 

Transportation and placement: when installing the space energy water heater, the transportation and installation should be handled with care. The solar energy should be placed in a sunny place and placed flat. The roof should be firmly connected with No. 8 iron wire or expansion screw or cement, and hard objects should be padded under the bracket. 

Otherwise, the exhaust water tank may not be blocked due to the exhaust vent. 

Vacuum tube: after the front and rear supports are connected with barrel brackets and lacing bars (stainless steel square tube supports have stainless steel connecting pieces for tightening). Place the water tank on the bucket holder, pay attention to the correspondence between the vacuum pipe hole of the water tank and the bottom bracket box of the bracket, install the ABS plastic bracket into the hole of the bottom bracket box, coat the decorative dust-proof rubber ring with water on the vacuum pipe, apply detergent as lubricant on the outer seal of the vacuum pipe, and insert the water with water into the inner hole of the water tank. After all the vacuum tubes are inserted, adjust the angle of the water tank. Then tighten the screw and insert the bottom of the vacuum tube back into the corresponding ABS bracket. 

Water pipe: when the inlet and outlet pipes are connected with pipe fittings, no water leakage is allowed. Do not screw the inlet and outlet pipes vigorously. Connect the upper and lower water pipes, and select special water pipes as far as possible to reduce the heat loss. The pipes should be insulated with thermal insulation materials, and the upper and lower pipes should be fixed on the support structure.